Home » Video » ...

2015 tacoma aftermarket headlights Videos

Projector Retrofit 2015 Tacoma

This is a little video we threw together last minute to show the process of retrofitting D2S projectors as well as color change LED halos into a set of stock 2015 ...

User Comments

J Fleming commented on 11 Mar 2016

Any tips for permaseal?

Matt “oneillm987” O commented on 12 Mar 2016

+J Fleming oh, you can just scrape it out of the channels and replace it with some butyl after.

J Fleming commented on 12 Mar 2016

+Matt “oneillm987” O I meant tips for headlights that already have permaseal. But I went ahead and bought some depot's off eBay and I know they're butyl so no worries.

Matt “oneillm987” O commented on 11 Mar 2016

Use butyl to seal the headlights it is the stickiest and when heated will mold into all the cracks without making a mess. Plus it is what most headlight housings are usually sealed with from the factory.

MikeandSamonPC commented on 09 Mar 2016

Do I need to have the actual car to align the projector horizontally? I'm about to do a retrofit for my dads Tacoma and he won't be around

Matt “oneillm987” O commented on 09 Mar 2016

You should because each car is gonna sit different so horizontal in one may not be in another, and therefore there's no way to know without throwing it in the car and lining it up. BUT with some careful measurement and a level and some tape I'm sure you can mark off the light before taking it off the truck so you know where level is ahead of time, and then line it up off the car.

Michael Smith commented on 01 Feb 2016

what halos did you use?

Matt “oneillm987” O commented on 02 Feb 2016

Thank you! We will be doing more videos, keep an eye out

Michael Smith commented on 02 Feb 2016

+Matt “oneillm987” Awesome build man! Thanks for the reply!

Matt “oneillm987” O commented on 02 Feb 2016

RGB halos from the retrofit source. I believe they were the 80mm size, but each shroud fits a different size depending what you want to do

Carter Myers commented on 29 Jan 2016

thanks for the video man! i plan on doing this with my 07 and i assume it will be relatively the same process. the only question i have is where did you run the wires for the halos? Also did you wire them independently from the headlights. Thanks again! Rock ON!

Matt “oneillm987” O commented on 30 Jan 2016

Yes we needed to drill a hole in the shroud and then there's plenty of room behind it for the wire

Carter Myers commented on 30 Jan 2016

+Matt “oneillm987” O oh okay. yeah I was just wondering cause that's the only thing that I wasn't sure how to go about. maybe just drilling a small hole in the shroud to run the wire through or something. guess I'll have to cross that bridge when I get there. haha

Matt “oneillm987” O commented on 30 Jan 2016

They are seperate, in fact the whole halo system is separate. luckily enough the control unit is based on a remote so you just keep all the wiring under the hood and then use the remote to change the colors. I wasn't there when he ran the wiring though because of work, I just helped with the install of the actual projectors and halos.